Amplificator Bose FreeSpace ZA 2120-HZA

The Bose® FreeSpace® ZA 2120-HZA zone amplifier is designed to provide basic amplification and sound system expansion when using front-end Bose products such as FreeSpace® integrated zone amplifiers and ControlSpace® engineered sound processors. With the inclusion of AmpLink, up to 8 digital audio channels can be sent to the amp from a Bose DSP via a shielded CAT 5 cable.

Mai multe detalii

Bose FreeSpace ZA 2120-HZA
Produs nou

3 993,00 lei

- +

Alerteaza-ma cand scade pretul

 
Mai multe detalii
  • POWER RATING
  • Amplifier Power 2 x 120 W @ 70/100V
  • AUDIO PERFORMANCE
  • Frequency Response 55 Hz - 20 kHz (+0/–3 dB, @ 1 W reference 1 kHz)
  • THD+N ≤ 0.3 % (at rated power)
  • Channel Separation (Crosstalk) ≤ –58 dBu (below rated power, 1 kHz)
  • Dynamic Range 88 dB
  • Audio Latency 1 ms (any analog input to loudspeaker output); 1.5 ms (AmpLink input to loudspeaker output)
  • AUDIO INPUTS
  • ANALOG                                                    AMPLINK
  • Input Channels 1 unbalanced, 1 balanced     8 digital
  • Connectors Stereo RCA, 5-pin Euroblock       RJ-45 (Input)
  • Input Range –8 dBu to 22 dBu
  • Input Impedance 20 kΩ
  • Maximum Input Level 22 dBu
  • Nominal Input Level 4 dBu
  • AUDIO OUTPUTS
  • ANALOG                                             AMPLINK
  • Outputs 2                                            8 digital
  • Connectors 2-pin inverted Euroblock     RJ-45 (Thru)
  • Nominal Output Level 2 x 120 W @ 70/100V
  • INDICATORS AND CONTROLS
  • Power LED Solid blue indicates power is on, blinking blue indicates standby mode.
  • Input Signal Clip LED Green indicates input signal is within –37 dBu to 11 dBu, red indicates signal is over 11 dBu.
  • Output Signal Clip LED Green indicates output signal is within –46 dBFS to –2 dBFS, red indicates signal is over –2 dBFS, approximately 80 W/
  • channel, for each output 120 watts is 0 dBFS.
  • AmpLink ERR LED Solid yellow indicates muted audio from the mute connector. Blinking yellow indicates an error, which will also mute the
  • audio.
  • AmpLink LNK LED Solid green indicates normal operation.
  • Controls, Front Panel Power On/Off
  • Controls, Rear Panel Auto Standby On/Off switch, Input: Dual/Summed switch, Remote 1 Control: Zone 1/Zone 1+2 switch, Output Voltage:
  • 70/100V switch, Mute, Output trims, Remote RJ-45
  • ELECTRICAL
  • Mains Voltage 100 VAC - 240 VAC (±10%, 50/60 Hz)
  • AC Power Consumption 13 W (Standby) 300 W (Max)
  • Mains Connector Standard IEC (C14)
  • Maximum Inrush Current 12.6 Amps (230 VAC / 50 Hz), 7.8 Amps (120 VAC / 60 Hz)
  • Overload Protection High temperature, output short, excessively low or high AC line voltage
  • PHYSICAL
  • Dimensions (H x W x D) 1.7" H x 19.0" W x 12.8" D (44 mm x 483 mm x 324 mm)
  • Shipping Weight 11.7 lb (5.3 kg)
  • Net Weight 9.5 lb (4.3 kg)
  • Cooling System Single fan creates continuous left-to-right air flow
  • GENERAL
  • Inputs (Control) 1 RJ-45 input connector for the CC-1 ControlCenter zone controller, or the CV41 4-to-1 converter. Mute input control viaa normally open contact closure.

Scrieţi o recenzie

Amplificator Bose FreeSpace ZA 2120-HZA

The Bose® FreeSpace® ZA 2120-HZA zone amplifier is designed to provide basic amplification and sound system expansion when using front-end Bose products such as FreeSpace® integrated zone amplifiers and ControlSpace® engineered sound processors. With the inclusion of AmpLink, up to 8 digital audio channels can be sent to the amp from a Bose DSP via a shielded CAT 5 cable.

Scrieţi o recenzie

 
Comments(0)

Nu sunt opinii ale clienților în acest moment.

Încă 30 produse în aceeași categorie:

Nu sunt produse

Se va calcula Livrare
0,00 lei Total

Finalizare